Using the Off-Set Method of calling CQ (The NA HSMS Self Test #2) 
Answers at the end ... (Test created by W5WVO & WA5UFH)

-----------------------------------------

1) The offset method of calling CQ is ONLY to be used for High Speed Meteor
Scatter operations.
A. True
B. False

2) When a station is calling CQ using the offset method, he MUST listen for
calls:
A. On the calling frequency
B. On his designated listening frequency (i.e., the offset he inserted in
his CQ)
C. Alternately on both frequencies
D. Simultaneously on both frequencies

3) When W1ABC is calling [CQ W1ABC U7] and is about to be answered by
another station, which station has his radio set for SPLIT operation?
A. Both stations
B. The station about to answer W1ABC
C. W1ABC
D. None of the above

4) If K4DEF decoded on 50.260 MHz [CQ W1ABC D7], where should he set his
transmit frequency to answer W1ABC?
A. SIMPLEX on 50.253.000
B. SIMPLEX on 50.267.000
C. SIMPLEX on 50.260.000
D. SPLIT, Tx on 50.253.000 and Rx on 50.260.000
E. None of the above

5) What action is required when a station who has been CQ using the offset
method answers a response to his CQ?
A. He exits the SPLIT mode by turning it off.
B. He verifies that his new Tx frequency is now the same as his Rx
frequency.
C. It is his option now to answer on either the offset or call frequency
D. Both A and B are correct
E. Both A and C are correct
F. None of the above

6) K4DEF decodes the following while tuned to 50.260.000:
131130 24.2  680 11 27  350      CQ U4 W1ABC FN32 CQ U4 W1ABC FN32 CQ U4
Which can be considered correct procedure for answering W1ABC's CQ?
A. Enter W1ABC into the "To radio" pane and click GenStdMsgs. Verify
that the Tx1 message is set, verify that the Tx First box is checked, set
your transceiver to SPLIT mode with a transmit frequency to 50.264.000 and a
receive frequency of 50.260.000, and begin the Auto call process.
B. Double-click on the call sign W1ABC in the decode window, verify that the
Tx First box is checked, adjust your receive/transmit frequency to
50.264.000, and begin the Auto call process.
C. Enter W1ABC into the "To radio" pane and click GenStdMsgs. Set the
message to Tx2, verify that the Tx First box is checked, adjust your receive/transmit
frequency to 50.264.350, adjust "Tol" to 100, and begin the Auto call process.
D. Both A and B are correct
E. Both B and C are correct
F. None of the above

7) In the example given in Question 6 above, and assuming both stations are
on PJ, what might be a good thing to post after completing the contact with
W1ABC?
A. Acknowledge to W1ABC that the contact was successfully completed
B. Tell W1ABC that he didn't follow correct procedure and to RTFM
C. Tell W1ABC that his initial DF was very high and that his rig might be off-frequency,
pasting in a line from his decoded CQ (as shown in Question 6) to illustrate this.
D. Both A and C are correct
E. Both B and C are correct
F. None of the above

-----------------------------------------
Answers:
1. B
2. B
3. C
4. A
5. D
6. F
7. D